H&H Menifee Concrete WorksH&H Menifee Concrete Works(951) 574-0417
H&H Menifee Concrete Works
(951) 574-0417Get an estimate

Concrete Contractor in French Valley, CA - Driveways and Patios Built on Solid Ground

H&H Menifee Concrete Works is a concrete contractor based in Menifee, CA. We pour driveways, patios, stamped concrete and garage floors for French Valley homeowners, plus bigger slabs for property owners who need them.

Get an estimate(951) 574-0417
Decorative concrete patio with a multicolored exposed-aggregate finish beside a stone house and wooden pergola.

French Valley homes and what they need from concrete

Most homes in French Valley are lived in by the people who own them, and you can hear it in the calls. People here plan to stay, so they ask about a wider driveway, a real patio out back, stamped work by the front door or a garage floor that's finally level, not a quick patch before a sale. The streets are mostly tract homes with two-car driveways and plain builder backyards. We do the same work in Temecula and Mead Valley, and the questions sound much the same.

What I can't tell from the street is the ground. It changes from lot to lot, and many tired slabs I look at were poured on dirt that was raked flat and never packed, so the base and the drainage come first on every estimate I write.

Concrete work we do for French Valley properties

We're best known for driveways, patios and stamped concrete, and our crew also pours garage floors, steps, footings, retaining walls and bigger slabs for property owners who need them. Every job starts the same way. I walk the property, look at how the ground sits and where the water goes, and measure before we talk about finishes. The base and the joints get planned first because they decide where and whether the slab cracks, and the look comes after that.

  • Concrete driveway building

    Driveways here usually crack or sink because the base was raked flat, not packed. We dig out and compact the subgrade, the ground under the slab, before any concrete arrives.

    Explore service

  • Concrete patio construction

    Many backyards here still have bare dirt or a small builder slab off the slider. We pour patios that slope away from the house so rain runs to the yard, not under your door.

    Explore service

  • Stamped concrete services

    Homeowners who plan to stay often want more than plain gray out back. Stamped concrete gives the look of stone or brick, and we press the pattern while the top is still soft.

    Explore service

  • Concrete sidewalk building

    Front walks and side-yard paths take daily feet and trash-can wheels, and a lifted edge trips people. We pour them on a packed base with a broom finish, a brushed texture for grip.

    Explore service

  • Garage floor concrete

    Garage floors here take years of tires, oil and dropped tools, and cracked or chipped slabs are common. We break out what's failed and pour a new floor that meets the driveway cleanly.

    Explore service

  • Decorative concrete

    Front entries and backyard seating areas here are where homeowners usually want color or texture. We add stain, exposed stone or a border, and plan the joints to fit the pattern.

    Explore service

  • Concrete retaining walls

    Sloped backyards and cut lots leave dirt pushing against fences and patios. We build concrete retaining walls on proper footings with drainage behind them, because trapped water is usually what pushes a wall over.

    Explore service

  • Concrete floor installation

    Workshops and add-on rooms on bigger lots need an inside floor that stays flat under weight. We pack the base, set rebar, steel bars that keep cracks tight, and finish it smooth.

    Explore service

  • Concrete pool decks

    Pool decks here sit in full sun and stay wet from splashing, so slick or hot surfaces are the usual complaint. We give them a textured finish and slope them toward drains.

    Explore service

  • Concrete steps construction

    Front steps on raised entries often settle or crack where they meet the porch. We form them with even rises and set them on solid footings so they hold their place.

    Explore service

  • Slab foundation building

    Room additions, casitas and detached garages on lots here start with a slab that carries walls, not just feet. We dig, pack and pour to the plans, with thicker edges where the walls land.

    Explore service

  • Foundation installation

    New shops, barns and homes on bigger parcels need a foundation sized for what goes on top. We dig the trenches, set the steel and pour to the engineer's plans.

    Explore service

  • Concrete parking lot building

    Small business lots, church lots and shared driveways take daily traffic and turning trucks. We pour thicker where the weight lands and slope it so rain doesn't sit in the stalls.

    Explore service

  • Concrete footings

    Patio covers, block walls and posts here all depend on what's in the ground under them. We dig footings to the depth the plans call for and pour them before anything goes on top.

    Explore service

  • Foundation raising

    When a corner of a slab or a house has dropped, doors stick and cracks open across the floor. We find why it sank before we lift and support it.

    Explore service

  • Concrete cutting

    Adding a drain line, widening a driveway or opening a doorway usually means cutting concrete that's already there. We saw straight, clean lines so new concrete meets old without a ragged edge.

    Explore service

Driveways, patios and slabs like the ones we pour

These photos show the kinds of driveways, patios and stamped work our crew forms, pours and finishes. Tap any of them to see the texture and joint lines up close.

  • Wide gray concrete driveway with expansion joints leading to a blue-gray house with two garage doors.

  • A stamped concrete patio with a reddish border surrounds dining furniture and leads to wooden steps beside a brick house.

  • A curved stamped concrete walkway with dark borders winds through a green garden toward a house porch.

Working in French Valley under Riverside County rules

When a job needs a permit out here, the paperwork and inspections run through the county, and that shapes the calendar more than most people expect. Here's how that works, and what moves the cost of your job.

Who issues permits and checks contractors here

French Valley is an unincorporated part of Riverside County, run by the county rather than a city, so there's no city building department. Permits come from the county's Building & Safety Department. When a job needs one, the pour waits on the county for the permit and the inspections, so a permitted job takes longer to start. I'd rather tell you that at the estimate than surprise you later.

When you're comparing contractors, the license to ask about is the state contractor license, because the county doesn't issue business licenses out here. On our side, we check which office covers your address, and when a permit's needed we file the application, set up the inspections and tell you before any work starts.

  • Questions about your own project go to Building & Safety at (951) 955-1800.
  • We tell you at the estimate if we expect a permit and why.
  • The county lists some small repairs as exempt, so ask about yours.

What moves the price and the calendar

The price on a French Valley job mostly comes down to size, how thick the slab needs to be for what's going on it, and how much old concrete has to come out first. Access matters too, because a backyard the truck can't reach means pumping or wheelbarrows. Stamped or colored finishes cost more than a plain broom finish, and soft ground that needs more base adds cost too.

The schedule turns on the permit, if your job needs one, and on the weather on pour day. After the pour comes curing, the wait while concrete gains strength, and you'll be walking on it well before you can drive on it. Your own price comes from the estimate, once I've measured and looked things over.

  • Tell us if an RV, trailer or work truck will park there.
  • Rain or high wind on pour day can push the date back.
  • Point out slopes, sheds or tree roots near the old slab.

Get a free on-site estimate for your French Valley concrete job

Call (951) 574-0417 or send the form, and we'll reply within one business day to set a time. I come out to your French Valley property myself, measure and look things over, then write up a free estimate that shows what's included, with no pressure and no obligation.

(951) 574-0417

What we run into on French Valley driveways and yards

Most of what goes wrong with concrete here starts below the surface or with the weather on pour day. These are the conditions I look for when I walk a property.

  • Driveway cracks that wander off

    When a driveway cracks in a jagged line across the middle, it usually means the control joints, the grooves that give a crack a straight place to go, were cut late or skipped. We cut ours soon after the pour so the slab shrinks and cracks along lines we planned.

  • Patios that drain toward the house

    Plenty of backyard slabs we see were poured flat or tipped the wrong way, so water pools at the slider after a rain. Before we form a patio, I check where water runs across the yard and give the new slab a gentle fall toward the grass or a drain.

  • Hot, dry wind on pour day

    Riverside County gets hot, dry Santa Ana winds every year, and wind like that pulls water out of fresh concrete before we can finish it, leaving a weak, dusty top later. When that weather's forecast, we start early, keep the slab damp and move the pour if we have to.

  • Slabs sinking by downspouts and sprinklers

    Where a downspout or a sprinkler dumps water at the edge of a slab, the dirt underneath softens and the concrete sinks or tilts. When we replace it, we dig out the soft ground, pack in a firm base and talk with you about moving that water somewhere else.

  • Room for a trailer or truck

    Plenty of owners here want a wider driveway, a side pad for a trailer or a spot for a work truck. Heavier loads need a thicker slab with steel in it, so tell me what's going to park there and I'll size the slab for that weight.

How we run a concrete job from estimate to cleanup

I started this business in 2017, after running a landscaping business where the concrete jobs were the ones I liked best. Here's how we work and why.

Why I'd spend your budget under the slab

On day one, nobody sees the base. It's just packed dirt and gravel inside the forms, so it's the first thing a tight budget wants to cut. But the base is what the slab rests on for as long as it's there, and a driveway poured on raked dirt settles right along with the dirt. A fancy finish on a weak base just cracks in a nicer pattern.

So if something has to give, I'll tell you to keep the digging, packing and steel and go simpler on the finish. You can stain or seal a sound slab later, but a bad base usually means tearing the whole thing out. I'd rather explain why concrete cracks before the job than after it, and I'm happy to go over it twice.

  • Licensed in California, insured every job

    We're fully licensed with the state and insured on every job, which matters most on the work where something can go wrong, like heavy tear-outs and retaining walls. I'm glad to go over both with you at the estimate, before you sign anything.

  • Same person from estimate to pour

    I write your estimate and I run the work on site, so the person who talked through the base with you is the one watching it get packed. Our crew does the forming, pouring and finishing, the same steps in the same order every time.

  • Satisfaction guaranteed on every job

    Satisfaction guaranteed on every job. In practice that starts before the pour, with a written estimate that spells out the base, the finish and the cleanup, so we both know what done looks like when the crew packs up.

  • Questions answered before you decide

    I'd rather answer ten questions up front than leave you guessing about cracks, curing or what's under the old slab. We take calls seven days a week, 7 AM to 10 PM, so call (951) 574-0417 or send the form and ask.

Questions French Valley homeowners ask about concrete

These are the questions I hear most on French Valley estimates, from county permits to cracks and cost. If yours isn't here, call and ask it.

How much does a new concrete driveway cost in French Valley, CA?

There isn't one price, because a French Valley driveway's cost comes down mostly to its size, its thickness and how much old concrete we break out and haul away. Widening into a side yard usually costs more than replacing the same footprint, since that ground has never carried a slab and needs digging out and packing. I'll put your own number in writing after I measure.

How do I know if my retaining wall in French Valley needs a permit?

Check with the county before you build, because Riverside County's permit flyer lists retaining walls among the work that needs a building permit. The same flyer lists fences over 6 feet and says to check with planning, and the county building ordinance leaves block walls over 4 feet high off its list of exempt fences. Bring your ideas for height and slope to the estimate, and we'll confirm the answer with Building & Safety before we set a date.

Does a concrete contractor in French Valley need a California license?

Yes, for most concrete jobs, because California requires a contractor's license when the project needs a building permit, uses any extra workers or comes to $1,000 or more. That $1,000 counts labor and materials across every contract on the project, so splitting a patio into small bills doesn't get around it. Those licenses come from the Contractors State License Board, so ask any contractor you're comparing for theirs.

How long will I be without my driveway after a new pour in French Valley?

Plan on parking on the street from the day we break out the old slab until the curing wait is over, and that wait is usually the longest part. Cars come back later than foot traffic, and a trailer or work truck should wait longer still. If you need a way in and out, ask at the estimate about pouring it in two halves so one side stays open.

What causes concrete driveways and patios to crack in French Valley?

Most cracks come from three things: a base that was raked flat instead of dug out and packed, control joints cut late or skipped, and a top that dried too fast in hot, dry wind. Some fine cracking is normal because concrete shrinks as it cures, and the joints are there so it cracks in a straight line we chose. Wide cracks or a slab that's sinking usually point to the ground underneath, and that's where we start.

Do I need a permit for a shed and concrete pad in French Valley?

A one-story storage shed of 120 square feet of floor area or less is on the county's exempt list, while the county's permit flyer lists sheds with more than 120 square feet of roof as needing a permit. Those rules are about the shed, not the pad under it, so for anything bigger, or a workshop with power, ask Building & Safety about the whole project before we pour. I'll tell you what I'd expect when I come out.

Service areas

Besides French Valley, we work in Menifee, Murrieta, Temecula, Wildomar, Lake Elsinore and other cities across southwest Riverside County. If yours isn't listed below, call or send the form and ask.

Ask about your location
(951) 574-0417Get an estimate