H&H Menifee Concrete WorksH&H Menifee Concrete Works(951) 574-0417

Decorative concrete in Menifee, CA - stamped color that suits how you use it

Plain gray slab or a patio that's tired? We give it color and pattern, with a new pour or a layer over what you have.

Decorative concrete patio with large tan stamped tiles, pergola, outdoor seating, and a stone fireplace.

Should I pour new stamped concrete or dress up the slab I already have?

Decorative concrete in Menifee, CA, is concrete that's colored and given a pattern so your driveway, patio or walk looks like stone, brick, wood or tile instead of plain gray, either with a new stamped pour or with an overlay on the slab you already have.

Most calls I get for decorative work start one of two ways. Either you've got a patio or walk that's solid but plain and you're tired of looking at it, or you're putting in something new and don't want it to look like a sidewalk.

The price moves with the size of the area, whether we pour new or overlay what's there, how much digging and base work the spot needs, any old concrete that has to come out, and how busy a pattern and how many colors you pick. The schedule turns on any permit the job needs, the weather on pour day and curing, the wait while the concrete hardens before you can walk or drive on it, and the estimate is where you'll see your own figure. We're fully licensed and insured, which California requires when a job needs a building permit, uses extra workers or runs $1,000 or more in labor and materials.

  • Stamped concrete is poured, colored, pressed with rubber mats while it's soft, then sealed.
  • An overlay is a cement-based layer bonded over existing concrete to freshen, level or restore it.
  • Sealing is part of every stamped job, because the sealer protects the color and surface.

What happens after you call us about decorative concrete in Menifee?

I come out myself to look at your job, and I run our crew on site when we do the work. Here's how it goes from your first call to the walk-through at the end.

  1. Call or send us a note

    Call (951) 574-0417 or use the form, and we'll get back to you to set a time for me to come out. It helps to have the rough size of the area, what it's used for and a few photos of any slab that's there now.

  2. I measure and write it up

    I come out, measure, check the ground and where the water runs, and talk through patterns and colors with you. Then I write up an estimate with each part of the work listed, so nothing about the price surprises you later.

  3. We handle permits and prep

    Once you say yes, we take care of any permit steps the job needs and let you know before work starts. Then we prep the ground or clean up the old slab so the new surface goes down on something solid.

  4. We pour, finish and walk it

    Our crew pours and stamps or lays the overlay and seals it, and I run the work on site. When it's done, I walk the finished job with you and go over how to look after it.

How we do decorative concrete, from the base up

If your slab is already in good shape, we'll talk about an overlay before anything else, because there's no sense breaking out sound concrete just to change how it looks. When the old slab is badly cracked or sinking, or there's nothing there yet, we dig out, pack the subgrade, the dirt the slab sits on, and set the slope so water runs away from your house. If the budget gets tight, I'd rather you pick a simpler pattern than cut corners on that base, because nobody sees it on day one and you can't fix it later without tearing out the pattern on top. We pour, color and press the pattern while the concrete is still soft, and on hot, dry, windy days, when the mix can set faster than a crew can stamp it, the usual answer is smaller sections and an early start. Then we seal it, and for spots that get wet, I'll ask whether you want grip added to the sealer.

Decorative work often sits beside other concrete jobs. A patio on a hillside usually needs concrete retaining walls built first so the ground behind it stays put, and if you want a solid slab inside a room or a shop, that's concrete floor installation.

  • A new stamped pour

    Best when there's bare ground or a slab too cracked or sunken to save. You get a fresh base and the pattern pressed in from the start, so the whole thing is built as one piece.

  • An overlay on your slab

    Suits a slab that's solid but plain or worn. The new layer bonds to what's there, so you skip tearing out concrete that's still doing its job.

  • Color mixed all the way through

    Integral color runs through the full depth, so a chip or a saw cut shows the same color as the top. It's the simplest way to color a slab, though it won't reach the deepest or brightest tones.

Get a written estimate for your decorative concrete

Send the form and we'll reply within one business day to set up a visit. I come out to measure and look things over, then write up a free estimate, and you're under no obligation to go ahead.

(951) 574-0417

Common questions about decorative concrete in Menifee

These are the questions I hear most when someone's weighing stamped concrete or an overlay. I'd rather answer ten questions before the pour than leave you guessing afterward, so ask me anything else when I come out.

How much does decorative concrete cost in Menifee, CA?

Your price comes from the estimate I write after measuring and seeing the spot, because the size, the base work and the finish you choose change it more than anything. An overlay on a sound slab usually costs less than tearing out and pouring new, and one color in a simple pattern usually costs less than several colors in a detailed one.

Which color method holds up best on a stamped concrete driveway?

One trade guide calls color hardener the common choice for driveways and anything that takes traffic, because it gives the surface a harder skin. The trade-off is that the color sits only in the top layer, so a deep gouge shows gray underneath, where color mixed all the way through would match.

How often does stamped concrete need to be resealed?

Common guidance is every two to three years, sooner on a driveway or a busy front entry and later on a shaded patio. The right schedule depends on the sealer and how exposed the surface is, so I'll tell you what to watch for on yours when we finish.

Is stamped concrete slippery when it's wet?

A freshly sealed stamped slab can be slick when wet, yes. The fix is a traction additive mixed into the final coat of sealer, which is worth asking for anywhere that gets wet, like a pool edge, a front walk or a spot the sprinklers hit.

How do I keep stamped concrete from cracking?

You can't make a slab crack-proof, but you can choose where it cracks by building on a well-packed base and cutting control joints, grooves that give the slab a planned place to crack. Stamped concrete cracks for the same reasons plain concrete does, so it needs joints on the same spacing, and they can be hidden in the pattern lines.

Who can help with permit questions for concrete work in Menifee?

The Menifee Permit Center guides applicants through the process, answers questions and helps with any documents a permit needs. When you hire us, we find out whether your job needs a permit and handle the application and inspections, so you usually won't have to call them yourself.

Decorative concrete in Menifee and the cities around it

We're based in Menifee and work the cities around it, from Perris to Murrieta. Depending on your address, permits come from the city or the county, so we check which and handle any permit the job needs.

(951) 574-0417Get an estimate